Polycom DOC2238A Instrukcja Użytkownika Pobierz pdf (Strona 24)

Chapter 2 - Hardware Installation

2-4

Unpacking and Positioning the MGC+100

To unpack and position the MGC+100:

1. When you receive your MGC+100, inspect the equipment for damage

and verify that the components match the packing slip. If you did not

receive a component or if there is damage to the system, notify your

service representative immediately.

Figure 2-1: MGC+100 package

2. Place the MGC+100 unit on a stable flat surface in a location that meets

the MGC+ environment requirements, which are:

— Operating temperature: 10°–40°C (50°–104°F) or 10°–35°C

(50°–95°F) when installed in a 19” rack

— Humidity: 15%–90% non-condensing

— Altitude: Up to 3,000m (10,000ft)

— ESD: +8 kV

3. Release the clasp locks at the bottom, and lift the MGC+100 top cover.

Carrying Strap

Lock in Open Position

Wood Packing Case

Lock in Closed Position

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 159 160

Brak uwag

Polycom DOC2238A Instrukcja Użytkownika Strona 24