Polycom DOC2558B Instrukcja Użytkownika Pobierz pdf (Strona 42)

Chapter 1- Hardware Description

1-36

5 Carefully slide the MPM/MPM+/MPMx card out through the front

panel.

Installing the Replacement MPM/MPM+/MPMx Card

1 On the card to be installed, move the ejector levers to their fully open

position.

2 Slide in the replacement MPM/MPM+/MPMx card.

3 Push the MPM/MPM+/MPMx card firmly into the Backplane,

making sure it is properly seated in its slot.

4 Ensure that the metal ejector levers are fully retracted into their

housings.

5 Tighten the captive screws on the front panel of the RMX that secure

the MPM/MPM+/MPMx card to the chassis.

Installing a New MPM/MPM+/MPMx Card in a Powered On

RMX 2000

1 If applicable, loosen the captive screws and remove the slot cover.

2 On the card to be installed, move the ejector levers to their full open

position.

3 Insert the card into the slot until the ejector levers touch the front

edge of the card cage.

4 Push the ejector levers to their closed position and tighten the captive

screws on each side of the card, securing the MPM/MPM+/MPMx

card to the RMX.

1 2 ... 37 38 39 40 41 42 43 44 45

Brak uwag

Polycom DOC2558B Instrukcja Użytkownika Strona 42